13
HNC3 825 / HNC3 825 perform
Safety instructions
2.7.1
Transport, setup, installation and disposal
Improper transport
Improper transport can cause the machine to tilt or fall. This can cause severe
crushing.
●
Carry out transport according to the specifications in this instruction.
●
Move unauthorised people out of the area.
●
Always clean and tidy the work area and cordon it off.
●
Ensure that there is room to escape should the machine fall.
●
Only use suitable lifting gear that has a sufficient load-carrying capacity.
●
Only attach lifting equipment to the attachment points provided. Never lift
the machine by its protruding parts.
●
Observe the machine's centre of gravity.
●
Take measures to prevent the machine from slipping.
●
Never lift loads over a person.
●
Do not stop below suspended loads.
●
Keep enough distance to the machine during transport.
●
Transport the machine as carefully as possible. Avoid mechanical vibration.
●
Chains, belts, ropes or other hoisting devices must be equipped with safety
hooks.
●
Do not use any torn, frayed or knotted chains, belts or ropes.
●
Ensure that chains, belts and ropes do not lie against sharp edges.
Incorrect setup and installation
Serious injuries and material damage.
●
Machine may only be set up by authorised, trained personnel who are
familiar with how to operate the machine and are in strict observance of all
safety instructions.
●
Before assembling and installing the machine, check to make sure it is com-
plete and in good condition.
●
Only assemble and install the machine if the machine and all of the parts
are complete and intact.
●
Do not setup machine in areas with high electromagnetic fields.
●
Keep the work area orderly and clean. Components and tools that are not
put in their correct place or put away may cause accidents.
●
Do not setup machine on escape routes.
●
Only place machine within buildings.
●
Place the machine on a level, sufficiently stable, non-slip and vibration-free
surface.
●
The foundation must comply with the norms stipulated in the technical lay-
outs.
●
Use safety equipment according to regulations and check that they function
correctly.
●
The load bearing capacity, the coating and the surface of the floor must not
be affected in the long term.
●
The working area must be adequately lit.
Summary of Contents for HNC3 825
Page 78: ...78 Disposal...
Page 79: ......
