76
Maintenance
Check the time it takes for the machine to come to a stop
Configuration of the machine without a motor brake:
The machine is not equipped with a motor brake. The design of the machine
guarantees that the cutterblock comes to a standstill within the legally applicable
standstill time of 10 seconds.
1.
Prepare the machine to operate.
2.
Switch the machine on and briefly let it run.
3.
Switch machine off with the red
[Stop]
button.
The cutterblock with clamped planing knives must be brought to a complete
stop within 10 seconds.
Machine stops within 10 seconds.
●
Checking the time for the machine to come to a stop completed.
Machine takes more than 10 seconds to stop.
●
If present: Switch off
[Main switch]
(position
"O" / "OFF"
).
●
Disconnect the machine from the mains power supply.
●
Contact Felder Group-service.
Check the extraction hood limit switch
1
2
Fig. 58: Check the extraction hood limit switch
1 Move the thicknesser table fully upwards
2 Swing up the extraction hood
The functionality of the limit switch is to be checked whilst the machine is running.
1.
Switch off the machine and secure it against being switched on again.
2.
Depending on the previous use, retool the machine for thickness planing.
3.
Move the thicknesser table fully upwards.
4.
Prepare the machine to operate.
5.
Switch machine on.
