Document #101-0086
27
5/22/07
VI. PROGRAMMING
The GL-ACW-P comes pre-programmed from the factory. However, you may decide to program the GL-
ACW-P to meet your individual needs. DO NOT program a category that you do not fully understand!
Refer to the Programmable Options section of this manual for a complete explanation of each
category’s function.
In order to program the GL-ACW-P, begin at the Welcome Prompt, then follow the steps
below:
1.
Open the machine, and locate the controller on the lower inside left
hand cabinet wall. Push the top and bottom buttons simultaneously for
about 3-5 seconds to enter the programming mode.
2.
To begin programming, you must use the buttons located on the inside
of the door above the display, numbered 1-4.
•
The #2 button is always used as a scroll button. The #4 button is always used
to enter a category. The #1 button is used to save options and exit that cat-
egory. The refund button is used to exit the programming mode.
Note: After three minutes of inactivity in programming mode, the machine will
automatically return to “normal” mode to prevent from being accidentally left
in the programing mode after completion.
In order to program the GL-ACW Park with an Ether Controller, begin at the Welcome
Prompt, then follow the steps below.
1.
Open the machine and locate the controller on the lower inside left hand cabinet wall.
2.
Press and Release the “Program” button on the controller.
3.
The display should now show “Inventory Deposits”.
4.
To begin programming, you will use the four button keypad on top of the internal dis
play and the refund button button located on the door.
•
The Refund button is used to exit the programming mode.
•
The F1 function button is used to save options and exit the category.
•
The F2 function button is used to scroll up through the categories.
•
The F3 function button is used to scroll down through the categories.
•
The F4 function button is used to enter a category.
When in the programming mode use the F2 or F3 function buttons to scroll up and down through the
menu choices. Once you have selected a category, use the F4 function button to enter into that category.
If a change is needed, then use the F2 or F3 function buttons to make that change. Once the change is
made press the F1 function button to exit the category.
5.
When all changes are complete and you are at the programming categories level (not
inside of a category) Press the “Refund” button (located on the door) to return to Wel
come message. Programming complete.
3.
The categories and specific programming instructions begin below and are
