Hamilton Beach Commercial HMI Series, Operation Manual

Page: 5 / 24

5
1/3
2/3
1/3
2/3
Attachments
Illuminated Variable Speed Dial
No light
Unit is turned OFF ( ).
1
Flashing Green Unit is ready to turn ON (blend).
2
Solid Purple Unit is ready to blend.
3
Solid Blue Unit is blending.
4
Flashing Blue Unit is blending in continuous run
mode.
5
Flashing
Yellow
Unit is starting to overheat. See
“Troubleshooting” section.
6
Flashing Red Error, see “Troubleshooting” section
Attachment Length Recommended Standard
Capacity
Uses
Whisk 10” (254 mm) Up to 4 gal (16 qts [15 L]) Batter, mayonnaise, egg
whites, pudding, mousse,
whipped cream
Stainless
Steel Blending
Attachment
12” (305 mm)
14” (355 mm)
16” (406 mm)
18” (457 mm)
21” (533 mm) Up to 6 gal (24 qts [23 L])
Up to 14 gal (56 qts [53 L])
Up to 23 gal (92 qts [87 L])
Up to 32 gal (128 qts [121 L])
Up to 42 gal (168 qts [156 L]) Soups, purees, compotes,
sauces, bisques, cooked
meats, gravy, liquefied
fruits, minces
If the Immersion Blender will not be used again within one hour, sanitize in the following manner:
1. Wash as instructed. (
, )
2. Following general cleaning, immerse attachment in a container of a cold, chlorine-based sanitizing solution that has a
minimum chlorine concentration of 100 parts per million for one minute. See recommended solution below.
3. Do not rinse. Allow attachment to air-dry before use.
Recommended Sanitizing Solution:
The sanitizing solution should consist of one tablespoon (14.8 ml) of household bleach per one gallon (3.8 L) of
clean, cool water (minimum 75ºF [24ºC] – 120ºF [49ºC]) mixed according to the instructions on the bleach. When
using a sanitizing solution other than that recommended, the sanitizing solution concentration should be tested using
commercially available test strips and should indicate a chlorine concentration between 100 and 200 parts per million.
Sanitizing Instructions
Ways to Hold the Immersion Blender
Icons Functions
Momentary Run: Blender motor
will turn off when you remove
finger from Start/Stop Trigger.
Continuous Run: Blender motor
locks in ON position. Turn motor
off by pressing Power Switch or
Interlock/Continuous Run Button.
OR
OR
X