HAMAR LASER STEALTH Series, General Training Manual, Page: 31 / 113

27
4. Move the target to Far Position B and tilt the Pitch Axis of the laser until the readout reads
zero.
Be sure to use only Pitch Axis adjustment knobs that face the target when tilting the laser beam (in the
setup displayed in Figure 18, this would be the PITCH adjustment).
5. Recheck the readings at the Near Position and at Far Positions A and B and adjust to zero if
necessary.
When the target reads zero at all three locations, the laser plane is parallel to the surface.
Figure 18 – 3
-Point Buck-In
3-Point Buck-In Procedure Using Multiple Targets
This method requires three targets. The procedure is basically the same as with one target, but it saves the
time required to move a single target to the three different footprints.
1. Zero all three targets on the near footprint (1)– see Figure 18 .
2. Place two of the targets on the other two footprints (two and three).
3. Tilt or aim the laser until all three readouts read the same numbers and the same sign.
4. When all three readouts read the same, the laser plane is then parallel to all three points.