27
Step 4: Laser Rough-in -- Position the laser until it is on target at the
Near Bore
Loosen the thumb screws on the L-111 stand and slide the assembly up or down until the laser beam is
visually
near the center of the target (you do not need the R-1307 for this). Tighten the thumb screws.
Note:
To aid in seeing the laser, tape a small piece of paper over the target window and trace an outline
of the target opening. Put a dot in the center of the circle to represent the target center.
Unlock the magnet holding the L-111 assembly and slide the whole assembly left or right until the laser
beam is
visually
near the center of the target. Turn the magnet back on.
Step 5: Laser Rough-in --
Move the target to the
Far Bore
Remove the target from the
Near
reference bore and insert it into
the
Far
reference bore, carefully
marking the placement of the
target in the bore with the cable at
6 o’clock.
Step 6: Laser Rough-in -- Steer the Laser to the
Center of the Target in the
Far Bore
Using the long micrometers on the L-111 stand, steer
the laser beam vertically and horizontally until it is
visually
near the center of the target (you do not need
the R-1307 for this).
Repeat Steps 4-6 until the laser is centered in the target
window (or the window outline on the paper taped
over the window).
Step 7: Place the L-102
over the post of the stand
Ensure the L-102 is seated
against the opposite post of
the stand and tighten the
thumb screw.
Summary of Contents for L-705
