HAMAR LASER L-705, Manual

Page: 14 / 49

11
Setting the Legs for the A-514GL (Using Large Bore Adapters)
The large leg gage can be used for all three bore adapters. When setting the legs for the
large
bore
adapter you must use the fixture extension.
Example: (see Figure 8)
1. To measure a 30 in. bore, each leg must be set to 15 in.
2. If using the 8 in. fixture extension, insert the extension into the hub and rest the other end in the slot.
3. Set the caliper to 7 in. and press one end of the caliper against the pin of the extension.
4. Slide the leg-setting plate up against the other end of the caliper.
5. After the leg setting fixture has been set to the correct length when using the large bore adapter, slide
the hub spacer on the hub to balance the bore adapter.
6. Slide the large bore adapter over the hub on the spacer and follow the method described in Setting the
Legs for the A-514GS
(
Using Small and Medium Bore Adapters
) on Page 10.
Figure 8 – Setting the legs for the A-514GL