MAN1544-5
6
1
About This Manual
1.1
Introduction
This manual contains all the information required to install, and operate the
ZoneSense PLUS - AR
Fire
Alarm Control Panel (FACP) and is only available to and for the use of personnel engaged in its installation,
commissioning and operation.
Using 3 levels of access the ZoneSense PLUS - AR Fire Alarm Control Panel ( FACP ) is controlled and
programmed through the keypad on the front panel.
Note:
To assist in the programming process the screens or Menus presented to the operator are
diagrammatically shown as an Appendix at the end of this document.
1.2
General Requirements
The
ZoneSense PLUS - AR
FACP has been designed and manufactured from high quality commercial
components so as to comply with major world standards. To ensure these standards are not compromised
in any way installation staff and operators should;
➢
Be qualified and trained for the task they undertake;
➢
Be familiar with the contents of this manual prior to the installation, commissioning or operation of
a
ZoneSense PLUS - AR
control system;
➢
Observe anti-static pre-cautions at all times; and
➢
Be aware that if a problem is encountered or there is any doubt with respect to the operational
parameters of the installation the supplier should be contacted.
1.3
References
ZoneSense PLUS
Technical Manual
ZoneSense PLUS
–
AR
Operation and Programming
Australian Standards:
AS4214
–
Gaseous Fire Extinguishing Systems
AS4428 - Fire Detection, Warning, Control and Intercom Systems
–
Control and Indicating Equipment. Part 1
and Part 5
1.4
Symbols
Important operational information
Note:
Configuration considerations
Observe antistatic precautions
Mains supply earth
DANGER mains supply present
