DUAL DRYER SYSTEM
INSTALLATION/SERVICE
MANUAL (L31279)
®
Cyclone/ADV for Consep
1. Ensure air pressure is at 0 PSI in air system.
2. Disconnect electrical connection.
3. Remove all four mounting nuts.
4. Remove cyclone and discard o-rings.
-OR-
If only replacing ADV for Consep, clean cyclone
and o-rings.
5. Apply grease to o-rings. Insert cyclone into
Consep housing. Align notch of cyclone
with Consep housing cutout.
Removal/Installation Instructions (cont’d)
Page 23
6. Install ADV for Consep. Tighten four mounting
nuts to 80-98 in-lbs (9-11 Nm).