67
Maintenance and Service
5.10.1 Adjusting the angle of the
side brush
The angle of the side brush (Fig. 19/1)
is set at the factory and may only need
to be adjusted following repairs .
1. Park the vehicle on a level piece of
ground. Switch the engine off and
actuate the parking brake.
2. Loosen the counternut (Fig. 19/2).
3. Use the adjusting nut to set the angle
of the side brush to approx. 3° to 5°
and then lock the adjusting nut again
with the counternut (Fig. 19/2).
5.10.2 Wear compensator for the
side brush
Check the side brush (Fig. 19/1) for
signs of wear every week. Proceed as
follows to make the adjustments in the
case the side brush is worn or changed:
1. Park the vehicle on an even surface
and raise the sweepings container.
Switch the engine off and actuate the
parking brake.
2. Adjust the height of the side brush
(Fig. 19/1) with the adjusting bolts
(Fig. 19/4).
3. Start the vehicle and lower the
sweepings container.
Side brush adjustment instructions:
12 to 4 o'clock (Fig. 20/X)
Fig.20
5.10.3 Changing the side brush
The side brush must be changed in the
case of wear down to a bristle length of
8 cm or less. The side brush can be di-
sassembled easily by means of a quick-
release lock.
1. Park the vehicle on an even surface
and raise the sweepings container.
Switch the engine off and actuate the
parking brake.
2. Raise the locking plate (Fig. 19/3),
turn the side brush (Fig. 19/1) to the
right and remove it.
3. Install the new side brush (Fig. 19/1)
and fix it in place with the locking pla-
te (Fig. 19/3).
4. Adjust the side brush, refer to Sec-
tion 5.10.2 and refer to Section
5.10.1.
5. Start the vehicle and lower the
sweepings container.
X
Summary of Contents for 1900 V
