Hakko Electronics Monitouch V9 Series, Troubleshooting Instructions Supplement

Page: 76 / 112

2-42 2. Local Mode Screen
11-5. Message Dialog Displayed during Data Transfer (between V9 and
Storage)
If an error occurs during data transfer, the message dialog shown
on the right is displayed on the V9 series unit.
Messages and their contents are shown below.
Messages Description
Work normally finished. The specified operation has been concluded normally.
Storage is not connected Storage is not connected
Storage Capacity over
Cannot write data to a storage device because the data size in the
V9 series unit is larger than the capacity of the storage device.
Write Protect: ON
Cannot write data to a storage device because the device is
write-protected with the write-protect switch.
Writing Error occurred. An error occurred during writing to a storage device.
Selected data does not exist. The data does not exist in the reading target.
Data type is different.
When writing to the V9 series unit, the type of data in the storage
device does not match the model of the V9 series unit.
Selected data cannot be read. Data in the storage device cannot be read.
Reading Error occurred.
An error occurred during writing to the flash ROM in the V9 series
unit.
Data discrepant
Data comparison found a discrepancy between the storage device
and the V9 series unit.
Undefined Error occurred. An error occurred due to a cause other than those mentioned above.
Invalid format.
The format of the file system in the storage device cannot be
identified.
Reformat it to FAT or FAT32 on the PC.
Cannot transfer this data to the connected
model. Data cannot be transferred because the type of data in the storage
device does not match the hardware version of the V9 series unit.