MANDO Adapt T211
Maintenance
Order h49 7144.907-333
75
INFORMATION
During removal of the product, take care not to lose
any components.
3. Dismantle the product as shown on the exploded draw-
ing. Pay attention to the following during disassembly:
Unfasten the coupling cover fixing screws uniformly,
alternately and crosswise.
Unfasten the adapter fixing screws uniformly, alter-
nately and crosswise.
Pay attention to the sequence and arrangement of
the springs because these need to be reinstalled in
the same place.
4. Clean all oil and grease residues off all components with
an ester-free, non-polar, soft, lint-free cloth and check
for visible signs of damage.
5. Assemble the product in accordance with the exploded
drawing and lubricate during assembly [see »Lubricating
the product« chapter]. Pay attention to the following dur-
ing assembly:
Replace worn or damaged fixing screws.
Tighten all fixing screws to the specified tightening
torque [see nomenclature and/or »Screw tightening
torques« chapter]. When tightening the screws, do
so evenly to prevent any distortion under load.
Only apply lubricant to the mechanical mating sur-
faces. Pay attention to notes about lubricants [see
»Use of lubricants« chapter].
Avoid too much lubricant on the locating face be-
cause this can cause face run-out errors.
Apply grease to the sealing elements [for example
O-rings, rectangular rings] and sealing surfaces.
Pay attention to notes about greases [see »Use of
lubricants« chapter].
Install the coupling cover as described below.
Reinstall the springs in the same sequence and ar-
rangement.
6. Conduct a function test of the coupling area of the prod-
uct [see »Installation of the product« chapter].
