MANDO Adapt T211
Installation
44
Order h49 7144.907-333
7.6.4 Installation of the adaptation clamping device
1. Attach any lifting gear that may be required.
2. If necessary, fit the mounting aid onto a vertically sus-
pended spindle.
3. Move the basic clamping device into its release position.
4. Set down the adaptation clamping device on the basic
clamping device so that the hole pattern on the basic
clamping device and the adaptation clamping devices
are aligned. For this, the surfaces of the clamping taper
in the basic clamping device and the adaptation clamp-
ing device must be aligned.
5. Screw in the adaptation clamping device fixing screws
and tighten to the specified tightening torque [see
»Screw tightening torques« chapter].
6. Unfasten and remove any lifting gear that may have
been required.
