– 67 –
Name
Description
Repair Action
32 Critical Lid Lock
Failure: Can't
Unlock
This fault is set when
the software has tried
multiple times to unlock
the lid without success.
Here are the specifics:
• Try to unlock 4 times
with a 1.5-second
delay between each
try.
•
After first 4 tries,
delay for 30-seconds
(cool down).
• Try to unlock 4
more times with a
1.5-second delay
between each try.
• If still not successful,
set fault.
• Replace lid lock and lid lock harness then run
below actions.
• Check the lid lock using Service Mode Spin
Test 14 to ensure lid lock operation.
• Verify that the lid lock is not blocked by any
external debris.
• Check lid switch continuity at J513 on the
control.
• Check continuity of lid lock position. Opened
or Closed.
• Check for proper operation of lid lock. 120
VAC while activating.
• Check lid lock wiring harness from the control
to lock assembly.
33,
34,
41,
42,
43,
44,
45,
46,
47,
48,
49,
50,
51,
66,
67,
68,
69,
71,
72,
73,
74,
75
Inverter Faults
Any of these faults can be
set if the inverter board
reports a fault.
• Run Service Mode Spin Test 14 to full
completion. If cycle fully completes, no further
action required.
• Check line voltage for 102 VAC to 132 VAC.
• Check all inverter board harness connections.
• Check motor TCO continuity at J502 (inverter
board). If open, should reset after 45-minutes.
• Check for continuity through each pair of
motor phase windings. If any windings found
open, replace motor.
• If the above repair actions don't clear the fault,
replace inverter board.
35,
59,
60,
61,
63,
64,
87,
88,
89,
90
Accelerometer
Fault
This fault is set when
any ADC Self-Diagnosis
channel reports an out-
of-tolerance value for
10-seconds.
• Run Service Mode Spin Test 14 to full
completion. If cycle fully completes, no further
action required.
• Check accelerometer board harness
connections.
• If the above repair actions don't clear the fault,
replace accelerometer board.
(
Continued next page
)
