– 44 –
Diagnostics and Service Information
The dryer control has a Service Mode test that can be utilized by the service technician in order to test
critical components and to access fault codes. This test mode will help the service technician to quickly
identify failed or improperly operating dryer components.
Diagnostic Guide
Before testing the dryer operation using the Service Mode, check the following:
1. Is the power cord plugged into the outlet?
2. Check for a bad house fuse or circuit breaker tripped?
3. Ensure the lint screen is clean and free of lint.
4. Before opening the dryer to access electrical components, remove power to the dryer.
5. Check all connections. Look for broken or loose wires, failed terminal, or wires not pressed into
connections thoroughly.
6. Check and clean connectors in common areas where the possibility of corrosion can occur.
Consumer Mode
To ENTER Consumer Mode:
Within 30 seconds after power on, press and hold
My Cycle
and Delay
Dry buttons. Then rotate the
Cycle
knob
more than six clicks.
Release the buttons.
• Upon entering Consumer Fault Mode, the control will display the faults listed in the table.
• Faults will only be displayed if they are active.
• Each press of the start button will advance to the next fault.
• If there are no faults in the log, the control will display "E00" on the display.
Service Mode
To ENTER Service Mode
: Press and hold the
Damp Alert
and
Timed Dry
buttons. Then, rotate the
Cycle
knob
more than six clicks.
Release the buttons.
General Navigation
•
Upon entering the Service Mode, the Seven Segment Display (SSD) will display the first test
number t01.
• Rotating the knob counter-clockwise (CCW) decrements the test number in the display.
• Rotating the knob clockwise (CW) increments the test numbers in the display.
• Once the test number is selected, pressing
Start/Pause
begins the selected test.
To EXIT Service Mode
: Press the
Power
button.
