– 18 –
Install Bracket to Washer
Install Dryer and Bracket on Dryer
WARNING:
Disconnect power before installing. Failure to do
so could result in serious injury or death.
WARNING
Excessive Weight Hazard. Failure to do the
following may result in back injury, other injury, or
property damage.
• Use two or more people to install the dryer.
• Avoid tipping and rupture of utility services.
• Dryer must be securely attached to the
washer.
• DO NOT place the washer on top of the dryer.
1. Lift the dryer on top of the washer. Protect
the washer control panel with cardboard or
other protection. Be sure to lift the dryer high
enough to clear the washer control panel.
2. Align the holes in the bracket with the holes in
the back of the dryer. Using a Phillips screw-
driver, attach the two #8 x 1/2-inch tapping
screws.
3. Tighten the dryer bracket screws, then tighten
all stacking kit screws.
1. Remove the washer top cap screw from the
rear left. Align the left bracket holes with the
top cap screw hole on the rear left of the unit
and replace the screw.
NOTE
: Leave the
screws loose so that the dryer hole alignment
will be easier.
2. Drive the next screw through the bracket into
the rear of the washer.
3. Repeat the above steps with the right side.
Washer
Top
Short screws into
brackets and washer
Long screws into
brackets and dryer
