OR-05/18/15
Maximizer
®
97 Owner’s Manual
27
Quality Water International
®
Assembly and Parts
Drive End Cap
Part #
Description
Qty.
Note
8
93583
Drive End Cap
1
Seals the two openings on the main control valve. The larger
diameter opening is sealed with an O-Ring used as an axial or “face”
seal. The O-Ring sits in a groove in the end cap. This groove must
be free of defects such as pits or scratches and also free of debris.
The smaller diameter seal is accomplished with an O-Ring used as
a radial seal. The O-Ring should be placed on the male boss on the
end cap. When assembling the end cap to the main control valve,
care should be taken to make sure the small O-Ring is aligned with
the opening in the main control valve and that the large
O-Ring stays in the groove in the end cap. If misaligned, the O-Rings
can become pinched and leak.
9
54202
Piston Slide
1
The slide should move freely inside the end cap housing.
10
90818
Screw
4
11
93699R-JG
Brine Valve
Housing Assembly
1
Attaches to the drive end cap with two 3/4-inch self-tapping screws
and has one O-Ring seal. The O-Ring is used as axial or “face” seal.
The O-Ring sits in a groove in the brine valve housing. The groove
and the face seal must be free of defects such as pits and scratches
or debris.
12
90821
O-Ring
1
13
54502KIT
Magnet Disk
Assembly
1
14
53511
Brine Piston
Assembly
15
90828
O-Ring
1
16
90819
O-Ring
1
17
53322
Drive Piston
Assembly
(includes 93839 -
Drain Gasket)
1
The drive piston attaches to the piston slide by placing the “slot”
of the piston onto the matching flat of the slide. To remove piston,
rotate piston 90° counterclockwise. To replace piston, rotate 90°
clockwise until you hear an audible “click.”
(see figure 10 below)
18
93839
Drain Gasket
1
Dimple
Align Flats
Position Piston Assembly (53322) Vertical
Slide Piston Assembly Onto Piston Slide.
Push Toward End Cap to Stop.
Rotate The Piston Assembly 90 Degrees
Clockwise Until You Hear An Audible Click
As It Snaps Into Place.
90°
Figure 10: Piston Slide Assembly