Hague Quality Water MAXIMIZER 97 Series, Owner'S Manual & Installation Manual

Page: 25 / 36

OR-05/18/15 Maximizer
®
97 Owner’s Manual 25
Quality Water International ®
Assembly and Parts
Bypass Valve
Part # Description Qty. Note
2 90827 O-Ring 1
3 90252 Blending Dial 1
The dial permits the addition of “untreated water” into the soft water
outlet. It is closed when pointing toward the main control valve and
open when pointing toward the inlet side.
4 90252 Cap - Blending Dial 1
The cap should be held in place by the three 1/2-inch self-tapping
screws and be in the proper orientation.
5 90802 Screw 5
6 90812 Tubing 5.0 inch 1
7 90226 Test Port Valve 1
The test port valve is used to draw water samples from the unit.
When the bypass valve is in the service position, the water tested
should be soft, treated water. When the bypass valve is in bypass
position, the water treated is from the raw, incoming water supply.
Note: there are two types of seals on the test port. One seal is
an O-Ring which seals off the threaded area when the valve is
opened. The other seal is a compression O-Ring seal between
the test port valve material and the bypass housing. If this seal is
“overtightened,” it can damage the O-Ring and cause a permanent
leak.
8 90828 O-Ring 1
9 90264 O-Ring 1
10 90809 Screw 1
11 93860
Turbine Sensor Wire
Assembly w/Cap
1
Picks up the magnetic field from the turbine and relays it to the
controller. Care should be taken when putting the sensor wire
into the sensor housing. The cap is then put in place and the self
tapping mounting screw is installed. A slot is provided in the cap for
the wire to exit. The three wire socket connector must be properly
installed in the controller. Stops on the connector prevent improper
(upside down) assembly. Do not force the connector past the stops.
12 93271 Turbine Sensor Housing 1
13 54320 Plastic Turbine Axle 1
Sits on a ridge in the main control valve side of the outlet stream of
the bypass valve assembly. Needs to fit around the Turbine Sensor
Housing (93271) when assembled. If the plastic turbine axle is
not correctly seated, the sensor wire may not sense the turbine
magnet.
14 90522 Turbine 1
The turbine must have a 1/8-inch diameter rare earth magnet
pressed into place adjacent to the axle opening. When assembled
to the axle, the turbine should spin freely. Do not use any lubricants.
If the turbine should become “jammed,” clean and flush the turbine
and bypass valve.
15 93838 O-Ring 2