Hagie UpFront STS 16, Operator'S Manual

Page: 39 / 127

IV.
OPERATING SYSTEMS
33
B. HYDROSTATIC DRIVE SYSTEM
Operating The Engine
FIG. 33-1
Pre-operational Checks Section Reference
1. Check the engine oil level. Do not oper-
ate when oil is below the low mark on
the dipstick.
2. Check the coolant level in the radiator
and the surge tank.
3. Check the hydraulic oil reservoir level.
4. Check the cooling air intake screen
5. Check the Filter Minder®.
6. Drain fuel/water separator.
7. Check engine drive belt.
8. Drain any water out of the air tank daily.
9. Check for any oil or fuel leaks and correct them if needed.
Start engine from operator’s seat only. When running engine
in a building, be sure there is adequate ventilation.
85
87
85
89
89
91
96
101
NOTE:
Cold oil may not flow
in quantities adequate
to prevent pump
cavitation.
BATTERY DISCONNECT-
The STS 16 is set up with a battery
disconnect safety device (fig. 33-1). This device is located on the under-
side of the machine. When the key is turned to the OFF position the
electrical circuit is broken therefore ren-
dering the machine unable to start. Do
not use this device as a safety when
working on the electrical system– discon-
nect the negative battery cable before
servicing the machine.
OPERATING SYSTEMS