SECTION 4 –
MAINTENANCE AND STORAGE
4-5
SERVICE - MOUNTING BOLT
TORQUE (60’ HSTB)
There are eight (8) mounting u-bolts (four
on each lift arm head) that mount the toolbar
to the lift arms. Re-torque each u-bolt to
150 ft.-lbs. after the first 10 hours of
operation. Re-torque again after the next 50
hours of operation. Thereafter, check u-bolt
torque yearly.
STORAGE
Preparing For Storage
1. Perform lubrication and maintenance
inspections, as required.
2. With the engine at normal operating tem-
perature, cycle all hydraulic functions.
3. Thoroughly rinse the spray system.
NOTE: Refer to your machine operator’s
manual for further information.
4. Thoroughly wash the attachment and
touch up any chipped or damaged paint.
5. Replace any damaged or missing decals.
NOTE: Contact Hagie Customer Support for
paint touch-up recommendations and
decal replacement.
6. Apply multi-purpose grease to hydraulic
cylinder rods.
7. Refer to the spray system console manu-
facturer’s operation manual for detailed
information on monitor and flow meter
storage procedures.
8. If the attachment will be stored sepa-
rately, ensure that all open ends (e.g.
hydraulic, electrical, solution, and foam
marker -
if equipped
) are capped or cov-
ered with a suitable covering.
Winterization Procedure
To winterize the NTB, it is recommended
that you use an environmentally safe type of
antifreeze and water mixture that will give
you adequate protection to -30° F.
Drain any remaining solution in the
system and rinse thoroughly. Run antifreeze
mixture through the system until it comes out
all attachment openings.
Removal From Storage
1. Remove any dried grease from the cylin-
der rods and re-apply, if necessary.
2. Thoroughly clean the attachment.
3. Carefully unseal any openings that were
sealed for storage.
4. Attach NTB to the sprayer and manually
cycle the hydraulics two or three times to
adequately lubricate components.
Mounting U-Bolts (8)
(Four u-bolts located on each lift arm head)
-Typical View
* 60’ HsTB only
Summary of Contents for 60' HsTB 24-Row
Page 47: ......
