2
WARNING:
INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN COMPLIANCE WITH IEC STANDARDS,
LEGAL REQUIREMENTS, AND SPECIFIC NATIONAL STANDARDS FOR PLUMBING AND ELECTRICAL
SYSTEMS.
BEFORE CONNECTING THE APPLIANCE, THE INSTALLER MUST REQUEST THE DECLARATION OF CONFORMITY
FOR THE PLUMBING AND ELECTRICAL SYSTEMS, AS REQUIRED BY
LAW NO.46 OF 05/03/90.
IN THE ABSENCE OF THIS DOCUMENTATION, HAFRO S.R.L. WILL DENY ANY RESPONSIBILITY FOR THE
BUILDING OR SYSTEMS, WHERE ITS APPLIANCES ARE TO BE INSTALLED.
ELECTRICAL SAFETY NOTE
Products are built in compliance with standards 60335.2.105. They are tested to personnel, in compliance with IEC standards and with directives currently in
effect in each single installer must also beaut horized to issue a certificate of conformity of properi installation. He must also require of the user (prior to
installation) a declaration of conformity of the systems of the building as required by law. In the absence of this documentation declines any responsibility for
the systems or premises where the product will be installed. The product must be firmly fixed and permanently attached to the electrical network and the
earthing system. Ascertain that the building’s electrical that the earthing system is efficient (refer to standard 64.8).
The product must be installed by authorised or qualified personnel, both as regards the electrical and plumbing connections. Before connecting the booth,
the installer must make sure that the electrical system complies with CEI 64.8 standards, the it is protected by a differential switch 0.03A, and that the
earthing system is efficient and complies with the aforementioned provisions. It is necessary to incorporate in the power supply network a disconnecting
device with a contact opening distance which allows complete disconnection in the conditions of the overvoltage category III, in accordance with the
installation rules.Connections to the electrical system must be made with an omnipolar switch with a contact aperture of at least 3mm, placed outside the
safety zones as set forth in the latest edition of technical standard CEI 64-8/7 (it must be from splashes or the water supply (see drawing). The electrical
system connection wire must be protected by a corrugated tube with no joins or intermediate connections. The wire must not have characteristics inferior to
those of type H05VV-F its section must be sized according to the model. The components used for connection must have specifications and IP protection as
set forth in standard 64.8 for applicatin in bath and showers.
GRUPPO GEROMIN S.r.l.
