HAEHNE
Elektronische Messgeräte GmbH · Heinrich-Hertz-Str. 29 · D-40699 Erkrath Germany · Telefon 0211/9 25 91-0 · Fax 0211/9 25 91-20
http://www.haehne.de
Email: [email protected]
HAEHNE
Elektronische Messgeräte GmbH · Heinrich-Hertz-Str. 29 · D-40699 Erkrath Germany · Telefon 0211/9 25 91-0 · Fax 0211/9 25 91-20
http://www.haehne.de
Email: [email protected]
DCX
12 Operation
12
By pressing a parameter field, the page for the change of values is displayed, in which the respective parameter values
can be set.
(All parameter are described in chapter 6.1. „Parameter of displayed Values“ )
For the data source, for example this is the following page:
This values are not saved permanently. This is especially useful in cases in which
different parameter values should be tried only. With restart the old parameter values are restored without
resetting each parameter.
The following page appears:
By pressing "Save", the modified values are transferred to the long-term storage.
In contrast, the page is exited by pressing "Esc" without saving any changes.
With "<" resp. ">" the position in the value field is selected.
With "˄" resp. "˅" the corresponding digit is increased or de
-
creased.
To exit the page without change, use „Esc“
In case of modified values "OK" appears. By pressing it, the
modified values are saved.
< > Esc
^
v OK
Position 1 Source (00101)
Actual Value: xxxxxxx
XX
y
Actual Value: xxxxxxx
Position 1 (001..)
Source: 51
Scale: xxxxx
Filter: xxxx
Unit: xx
Esc
y
Position 1 (001..)
Save
Thus, the modified values even after a restart are still
present, the field designated here as "y",must be
pressed in the parameter selection page.
