Hach si792 D series, User Manual

Page: 37 / 96

35
Section 5 Operation—si792(x) D
(4–20 mA/HART)
The following section describes how to navigate and operate the
si792(x) D transmitters.
5.1 Measure mode
In the measure mode the display shows the dissolved oxygen value
and the temperature. The status bar is shown above the measure mode
indicator.
• To return to the measure mode from the configure menu, press
CONF
and then
ENTER
.
• To return to the measure mode from the calibration menu, press
CAL
and then
ENTER
.
Note: The waiting time for the stabilization of the measured value is
approximately 20 seconds.
5.2 Configuration
Use the configuration mode to specify the sensor, range and other
parameters for the system as shown in
Table 8
.
1.
Press
CONF
and enter
1200
to enter the configuration mode.
2. Use the arrow and enter keys to change the settings. All settings
and options are shown in
section 5.2.1
,
section 5.2.2
,
section 5.2.3
,
section 5.2.4
and
section 5.2.5
.
Table 8 Configuration menu
Code Setting Passcode