Hach si792 D series, User Manual

Page: 45 / 96

43
Section 6 Operation—Foundation
Fieldbus
The following section describes how to navigate and operate the
si792x D-FF. The transmitter can be operated as follows:
• Direct interface with the transmitter (
section 6.1
)
• Foundation Fieldbus communication (
section 6.2 on page 46
)
6.1 Configuration
Use the configuration mode to specify the sensor, range and other
parameters for the system.
6.1.1 Configuration steps
Complete the following steps to configure the si792 transmitter.
1.
Press
MEAS
+
CAL
and enter
1200
to enter the configuration
mode.
2.
Use the arrow and enter keys to change the settings. All settings
and options are shown in
section 6.1.2
.
To exit the configuration mode at any time, press
MEAS
+
CAL
and
then
ENTER
. The Hold mode will be active for 20 seconds and then the
measured value will be displayed.
Note: During configuration the transmitter remains in the Hold mode for
safety reasons. The Sensoface icon is inactive. The configuration mode
indicator is displayed (
Figure 10 on page 31 ).