4.
Connect Tygon
®
tubing from the pump (2) to the measuring cell.
5.
Connect Tygon
®
tubing from the pump (1) to the reagent canister.
6.
Connect the pump cable (4) to the electronic unit according to the pump function
(refer to
Table 6
on page 20 and
Table 7
on page 20).
7.
Reconnect power to the analyzer.
8.
Adjust the flow rate as required (3).
8.8.3 Pulse pump
D A N G E R
Electrocution hazard. Always make sure the analyzer is turned off and power is disconnected
before installing this option.
Figure 19 Pulse pump
Install the pump as follows:
1.
Install the pump on the front of the panel in one of the available slots (see
Figure 10
on page 37) using the 2 screws.
2.
Connect the pump cable (3) to the electronic unit according to the pump function
(refer to
Table 6
on page 20 and
Table 7
on page 20).
3.
Replace the cover on the back of the panel using the 4 screws.
4.
Connect the outlet
OUT
(1) to the tube (4) using Tygon
®
1.6 x 3.2 tubing and insert
into one of the five slots in the measurement chamber cover.
5.
Connect the inlet
IN
(2) to the reagent canister using Tygon
®
1.6 x 3.2 tubing.
8.9 Canister kit
D A N G E R
Electrocution hazard. Always make sure the analyzer is turned off and power is disconnected
before installing this option.
The reagent pumps, automatic calibration and the chemical cleaning options can all be
delivered with a 10 liter canister equipped with a level detector, strainer, and tubing for
connection to the pumps.
Refer to
Reagent level detector
on page 20 for information on wiring the level detector to
the analyzer.
Additional options
48
Summary of Contents for POLYMETRON 8810
