- 6 -
1CE
"Ice"-Potential freeze condition
detected.
Not action required. All the equipments will be
automatically activated regardless of spa status. The
equipment stays on 4 minutes after the sensors detect that
the spa temperature has arisen to 45°F/7.2℃ or higher, An
optional freeze sensor may be added to protect against
extraordinary freeze condition. Auxiliary freeze sensor
protection is advisable is colder climates. See your dealer
for details.
(
Ⅱ
-2)
、
USA BALBOA control system :model GS100
GS100 (for two SPA massage pumps)
GS100 Control Reference Card
Non-Circ Operation
Initial Start-up
When your spa is first actuated, it will go into Priming mode, indicated by
“
”
Please see the M-7
Installation Instruction Manual for complete instructions on Power-up and Pump Priming .
The
Priming mode will last for less than 5 minutes (press "Temp" or "Set" to skip Priming Mode) and then the
spa will begin to heat the spa and maintain the water temperature in the Standard mode.
Temp/Set(80°F - 104°F / 26°C - 40°C)
The start-up temperature is set at 100F°/37°C. The last measured temperature is constantly displayed on
the LCD.
Note that the last measured spa temperature displayed is current only when the pump has been
running for at least 2 minutes.
To display the set temperature, press the “Temp” or “Set” pad once.
To change the set temperature, press the pad a second time before the LCD stops flashing. Each press of the
“Temp” or “Set” pad will continue to either raise or lower the set temperature. If the opposite direction is
desired, release the pad and let the display revert to the current water temperature. Press the pad to display
the set temperature, and again to make the temperature change in the desired direction.
After three seconds, the LCD will stop flashing and display the current spa temperature.
