H3C UniServer R6700 G3, User Manual

Page: 49 / 151

6-16
IMPORTANT:
Skip this step if no power fail safeguard module is required or the storage controller has a
built-in flash card. For information about storage controllers with a built-in flash card, see
"Storage controllers."
a.
Install the two internal threaded studs supplied with the power fail safeguard module on the
standard storage controller.
b.
Slowly insert the flash card connector into the socket and use screws to secure the flash
card on the storage controller.
c.
Connect one end of the extension cable provided with the power fail safeguard module to
the supercapacitor.
CAUTION:
Make sure the extension cable is the correct one. For more information, see Table 6-3 ..
2.
(Optional.) Install the supercapacitor in the supercapacitor container:
a.
Insert the supercapacitor into the supercapacitor container and place the supercapacitor
cable into the cable clamp.
b.
Insert the supercapacitor container into the target slot on the front panel, and use the screw
to secure the supercapacitor container.
c.
Install the security bezel. For more information, see " Installing the security bezel ."
3.
Install the standard storage controller to the riser card. Insert the storage controller into the
PCIe slot along the guide rails, and use the screw to secure it into place.
4.
Install the riser card to the server. For more information, see " Replacing riser cards and PCIe
modules ."
5.
Connect the drive data cables to the standard storage controller. For more information, see
"
Connecting internal cables ."
6.
Connect the other end of the extension cable provided with the power fail safeguard module to
the flash card.
{
If the storage controller is installed with an external flash card, connect the supercapacitor
extension cable to the flash card.
{
If the storage controller uses a built-in flash card, connect the supercapacitor extension
cable to the supercapacitor connector on the storage controller.
7.
Install the processor mezzanine board:
a.
Align the standouts on both sides of the processor mezzanine board with the notches on the
chassis edges, and place the processor mezzanine board in the chassis.
b.
(Optional.) Install the supercapacitors. Insert the connector end of a supercapacitor into the
holder. Pull the clip on the holder, insert the other end of the supercapacitor into the holder,
and then release the clip.
c.
Close the handle of the processor mezzanine board.
8.
Install the access panel. Place the access panel on top of the server chassis and slide the
access panel toward the server front until it snaps into place.
9.
Rack-mount the server. For more information, see " Rack-mounting the server ."
10.
Connect the power cord. For more information, see " Connecting the power cord ."
11.
Power on the server. For more information, see " Powering on the server ."