3-4
Connecting an Ethernet cable
About this task
Perform this task before you set up a network environment or log in to the HDM management
interface through the HDM network port to manage the server.
Procedure
1.
Determine the network port on the server.
{
To connect the server to the external network, use the Ethernet port on the Ethernet
adapter.
{
To log in to the HDM management interface, use either of the following HDM network ports:
−
HDM dedicated network port on the server. For the position of the HDM dedicated
network port, see "Rear panel view."
−
HDM shared network port on the sLOM Ethernet adapter (if any). For the position of the
HDM shared network port, see "
Replacing the sLOM Ethernet adapter
2.
Determine the type of the Ethernet cable.
Verify the connectivity of the cable by using a link tester.
If you are replacing the Ethernet cable, make sure the new cable is of the same type with the old
cable or compatible with the old cable.
3.
Label the Ethernet cable by filling in the names and numbers of the server and the peer device
on the label.
As a best practice, use labels of the same kind for all cables.
If you are replacing the Ethernet cable, label the new cable with the same number as the
number of the old cable.
4.
Connect one end of the Ethernet cable to the network port on the server and the other end to
the peer device.
Figure 3-5 Connecting an Ethernet cable
5.
Verify network connectivity.
After powering on the server, use the
ping
command to test the network connectivity. If the
connection between the server and the peer device fails, make sure the Ethernet cable is
correctly connected.
