6-26
4.
Install the heatsink onto the server.
a.
Place the heatsink on the processor socket. Make sure the alignment triangle on the
retaining bracket and the pin holes in the heatsink are aligned with the cut-off corner and
guide pins of the processor socket, respectively.
b.
Fasten the four captive screws on the heatsink from screw 1 to screw 4 as shown by the
marks on the heatsink.
CAUTION:
To avoid poor contact between the processor and the system board or damage to the pins in
the processor socket, tighten the screws to a torque value of 1.4 Nm (12 in-lbs).
5.
Paste bar code label supplied with the processor over the original label on the heatsink.
IMPORTANT:
This step is required for you to obtain H3C's processor servicing.
6.
Install the removed processor mezzanine board.
7.
Install the access panel. Place the access panel on top of the server chassis and slide the
access panel toward the server front until it snaps into place.
8.
Rack-mount the server. For more information, see "
9.
Connect the power cord. For more information, see "
10.
Power on the server. For more information, see "
Verifying the replacement
Log in to HDM to verify that the processor is operating correctly. For more information, see HDM
online help.
