H3C UIS-Cell 3000 G3, User Manual

Page: 80 / 171

73
d.
Connect the SATA M.2 SSD cable to the system board. For more information, see
"
Connecting the SATA M.2 SSD cable ."
11.
(Optional.) Install the removed security bezel. For more information, see " Installing the security
bezel ."
12.
Install the removed fan cage. For more information, see " Installing fans ."
13.
Install the removed chassis air baffle. For more information, see " Installing air baffles ."
14.
Install the access panel. For more information, see " Installing the access panel ."
15.
Rack-mount the server. For more information, see " Rack-mounting the server ."
16.
Connect the power cord. For more information, see " Connecting the power cord ."
17.
Power on the server. For more information, see " Powering on the server ."
Installing an optical drive
Preparing for the installation
Use Table 8 to determine the location of the optical drive you are installing depending on the type of
the optical drive.
Table 8 Optical drive installation locations
Optical drive Installation location
USB 2.0 optical drive Connect the optical drive to a USB 2.0 or USB 3.0 connector on the server.
SATA optical drive
IMPORTANT:
Only the UIS-Cell 3010 G3 server supports the SATA optical drive.
Install the optical drive in drive cage bay 1 of the UIS-Cell 3010 G3 server.
For the location of drive cage bay 1, see "Front panel view."
Installing a SATA optical drive
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Remove the chassis air baffle. For more information, see " Removing air baffles ."
5.
Remove the fan cage. For more information, see " Replacing the fan cage ."
6.
Remove the security bezel, if any. For more information, see " Replacing the security bezel ."
7.
Remove the screws that secure the drive cage bay blank over drive cage bay 1, and then push
the blank from the inside of the chassis to remove it, as shown in
Figure 102 .