84
Replacing hardware options
If you are replacing multiple hardware options, read their replacement procedures and identify
similar steps to streamline the entire replacement procedure.
Replacing the security bezel
1.
Insert the key provided with the bezel into the lock on the bezel and unlock the security bezel,
as shown by callout 1 in
CAUTION:
To avoid damage to the lock, hold down the key while you are turning the key.
2.
Press the latch at the left end of the bezel, open the security bezel, and then release the latch,
as shown by callouts 2 and 3 in
.
3.
Pull the right edge of the security bezel out of the groove in the right chassis ear to remove the
security bezel, as shown by callout 4 in
Figure 115 Removing the security bezel
4.
Install a new security bezel. For more information, see "
Replacing a SAS/SATA drive
The drives are hot swappable.
Procedure
1.
Remove the security bezel, if any. For more information, see "
2.
Observe the drive LEDs to verify that the drive is not selected by the storage controller and is
not performing a RAID migration or rebuilding. For more information about drive LEDs, see
"Drive LEDs."
3.
Remove the drive: