3
Figure 3 L2PT network diagram
L2PT tasks at a glance
To configure L2PT, perform the following tasks:
1.
Enabling L2PT or L2PT drop
{
This feature is applicable only to customer-facing ports.
2.
(Optional.)
Setting the destination multicast MAC address for tunneled packets
Enabling L2PT
Restrictions and guidelines for L2PT
•
To enable L2PT for a Layer 2 protocol on a port, perform the following tasks:
{
Enable the protocol on the connected CE, and disable the protocol on the port.
{
Disable the protocol (for example, STP) on the PE ports connecting to an aggregate
interface on a CE when the following conditions exist:
−
The protocol is running on the aggregate interface on the CE.
−
The aggregate interface on the CE connects to an L2PT-enabled port on the PE.
{
Enable L2PT on PE ports connected to a customer network. If you enable L2PT on ports
connected to the service provider network, L2PT determines that the ports are connected
to a customer network.
{
Make sure the VLAN tags of Layer 2 protocol packets are not changed or deleted for the
tunneled packets to be transmitted correctly across the service provider network.
•
L2PT for LLDP supports LLDP packets from only nearest bridge agents.
•
You can enable L2PT on a member port of a Layer 2 aggregation group, but the configuration
does not take effect.
•
Do not enable L2PT on a port that is going to join a service loopback group.
Summary of Contents for S6850 Series
Page 108: ...48 WGE1 0 3 32768 49153 50100 0x7b 0001 0001 0001 ACDEF...
Page 259: ...21 6 N A 200 6...
Page 337: ...ii...