8
Restrictions and guidelines for many-to-one VLAN mapping in dynamic IP address
assignment environment
To ensure correct traffic forwarding from the service provider network to the customer network, do
not configure many-to-one VLAN mapping together with uRPF. For more information about uRPF,
see
Security Configuration Guide
.
To modify many-to-one VLAN mappings, first use the
reset dhcp snooping binding
command to clear the DHCP snooping entries.
Many-to-one VLAN mapping in dynamic IP address assignment environment tasks at a
glance
To configure many-to-one VLAN mapping in dynamic IP address assignment environment, perform
the following tasks:
1.
2.
3.
Configuring the customer-side port
4.
Configuring the network-side port
Enabling DHCP snooping
1.
Enter system view.
system-view
2.
Enable DHCP snooping.
dhcp snooping enable
By default, DHCP snooping is disabled.
Enabling ARP detection
1.
Enter system view.
system-view
2.
Enter VLAN view.
vlan
vlan-id
3.
Enable ARP detection.
arp detection enable
By default, ARP detection is disabled.
You must enable ARP detection for the original VLANs and the translated VLANs.
Configuring the customer-side port
1.
Enter system view.
system-view
2.
Enter interface view.
{
Enter Layer 2 Ethernet interface view.
interface interface-type interface-number
{
Enter Layer 2 aggregate interface view.
interface bridge-aggregation interface-number
3.
Set the link type of the port.
port link-type
{
hybrid
|
trunk
}
By default, the link type of a port is
access
.
4.
Assign the port to the original VLANs and the translated VLAN.
{
Assign the trunk port to the original VLANs and the translated VLAN.
Summary of Contents for S6850 Series
Page 108: ...48 WGE1 0 3 32768 49153 50100 0x7b 0001 0001 0001 ACDEF...
Page 259: ...21 6 N A 200 6...
Page 337: ...ii...
