EN
9
Operating manual
GYSFLASH S 4.12
Translation of the original
instructions
Step
1
: Analysis
Analyses the battery state (charge level, polarity inversion,
wrong battery…)
Step
5
: Charge
(
0.8A
4A)
Fast charge with maximum current that can reach 80% charge
level.
Step
2
: Recovery
(
0.5A
2A)
Damaged elements recovery due to an extended deep
discharge algorithm.
Step
6
: Absorption
(14.4V or 14.7V with AGM option)
Constant voltage charge to reach a 100% charge level.
Step
3
: Test
Sulfated battery test.
Step
7
: Floating charge
(13.6V)
Maintains battery charge level at its maximum.
Step
4
: Desulfation (
15.8V)
Battery desulfation algorithm.
• Estimated charge time
Battery capacity
2Ah
8Ah
15Ah
18Ah
50Ah
90Ah
Charging time 20% >>> 80%
2h
6h
11h
3h
8h
14h
If the motorbike is fitted with a 12V plug, the GYSFLASH S 4.12 can charge the battery via this plug with the CAN-BUS
system, without switching the dashboard on. In this setup, connect the cigarette lighter adapter on the charger and on
the motorbike’s 12V socket then follow the «start up » procedure on the previous page. In certain cases, it is possible
that the charge will only start 2 minutes after performing the connections.
• Protections :
The GYSFLASH S 4.12 has several features to protect it against short-circuits or polarity inversion. It has an an-
ti-spark feature which prevents sparks whilst connecting the device to the battery. This charger has double insulation
and is compatible with vehicle’s onboard electronics.
The GYSFLASH S 4.12 is fitted with an integrated temperature probe that ensures that the charging current is adapted to the am
-
bient temprature to prevent internal electronics’ overheating.
TROUBLESHOOTING
Symptoms
Causes
Remedies
1 The indicator
blinks.
• Polarity inversion
• Battery voltage is too high
• Clamps in short-circuit
• Check that the clamps are properly connected.
• Check that it is a 12V battery.
2 The indicator
is on.
Charge failure, battery non recoverable. Change the battery and press
to restart a
charge.
3 The indicator
stays on even after pres-
sing the
button.
Thermal protection.
Ambient temperature is too high (>50°C), cool the
room and let the charger cool down.
4 The indicator
blinks.
Charger in sleep mode.
Press the button
or connect a battery to the
charger to exit sleep mode.
5 The indicator stays on.
Charge interrupted by pressing the
button.
Press
again to restart the charge.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
