25
.............................
CCEC/ OM Manual GlasStile GSR 1.6 EN
07
.2009
For rails, which do not conform to the standard specifications, refer to
Gunnebo Technical Department
Casework Type A
Type A Casework does not have glass panels. The column rotates symmetrically within
the perimeter formed by tubular steelwork. The steelwork is delivered disassembled, i.e.
the posts are not connected to the horizontal rails.
A1.
Assemble the posts to the curved horizontal rails using the M8 fixings supplied (bolt,
washer, shake-proof washer), 1 N
o
/rail, hand tight only. Check rail is at a right angle to
post.
A2.
Tape the flange covers near the tops of the posts. Take care to protect decorative
finishes.
A3.
Position the posts at the previously marked positions (see Fig 4.1) and assess
correctness of location relative to the Rotor, checking and adjusting if necessary for the
correct vertical and horizontal alignment. Make any necessary small adjustments for
manufacturing tolerances, and mark the fixing holes.
A4.
Remove the casework; drill the M10 fixing holes for the M8 fixings and fit. If using
chemically fixed studding, ensure that the studding is cut 15mm above floor level.
A5.
Replace the casework and fix in place, checking and adjusting if necessary, the vertical
and horizontal alignment.
A6.
Remove the tape from flange covers. Position the fixing flange cover rings, securing with
silicone adhesive to the fixing flange to prevent any
“rattle”.
A7.
Glue the Top Cap to each post using Loctite 663, or as supplied.
Casework Type B
Type B Casework does not have glass panels. The column rotates asymmetrically within
the perimeter formed by tubular steelwork.
B1.
Tape the flange covers near to what would be the tops of the posts. Take care to protect
decorative finishes.
B2.
Position the posts at the previously marked positions (see Fig. 4.2) and assess the
correctness of location relative to the Rotor, checking and adjusting if necessary for the
correct vertical and horizontal alignment. Make any necessary small adjustments for
manufacturing tolerances, and mark the fixing holes.
B3.
Remove the casework; drill the M10 fixing holes for the M8 fixings and fit. If using
chemically fixed studding, ensure that the studding is cut 15mm above floor level.
B4.
Replace the casework and fix in place, checking, and adjusting if necessary, the vertical
and horizontal alignment.
B5.
Remove the tape from the flange covers. Position the fixing flange cover rings, securing
with silicone adhesive to the fixing flange to prevent rattle and then lift in to position and
secure the curved guide rail.
IMPORTANT
FOR ALL CASEWORK, DO NOT DRILL FIXING HOLES PRIOR TO GLSR
DELIVERY TO SITE AND LOCATION CONFIRMATION AS BELOW
