GUDEL ZP 3-5 V4, Operating Manual

Page: 259 / 354

Replace the motor as follows:
1 Switch off the plant and padlock it to prevent it from being switched on
again
2 Remove the cables and lines
3 Remove motor
Ü
Chapter 10.2.2.3,
2
248
4 Remove the elastomer gear rim if necessary
5 Measuring the Y distance
6 Release the coupling screws
7 Remove the coupling half
8 Replacing the motor
9 Apply corrosion protection agent to the motor shaft with a brush
10 Push the coupling half onto the motor shaft
11 Set the Y distance
12 Tighten the coupling screws:
12.1 Tighten alternately to 50% of the tightening torque TA
12.2 Tighten alternately with 100% of the tightening torque TA
13 Installing the motor and coupling
Ü
Chapter 10.2.2.7,
2
255
14 Connect the cables and lines in accordance with the electrical diagram
15 Calibrate the reference plane of the motor (this procedure is described
in the documentation for the complete system or the motor)
The motor has been replaced.
Repairs OPERATING MANUAL ZP 3-5 V4
72057594174110603_v5.0_
EN-US
259