GUDEL ZP 3-5 V4, Operating Manual

Page: 266 / 354

Set the gear backlash as follows:
1 Switch off the system and padlock it to secure it against being switched
on again
2 Disassemble the drive
3 Remove all screws on both sides
4 Rotate both covers toward the next higher, cast-in number
5 Tighten four screws on each of the two sides
6 Checking the gear backlash: Rotate the worm shaft 360° by hand
6.1 The shaft does not resist rotation: Repeat from step 3
6.2 The shaft resists rotation: Remove the screws, set both gearbox
covers one level lower
6.3 The shaft always resists rotation: Replace gearbox unit immediately
7 Insert all screws on both sides and tighten crosswise
8 Checking the gear backlash: Rotate the worm shaft 360° by hand
The shaft resists rotation: Repeat from step 3
The gear backlash has been set.
Repairs OPERATING MANUAL ZP 3-5 V4
72057594174110603_v5.0_
EN-US
266