GÜDE Expert Power Control 8291, Manual

Page: 28 / 91

28
Expert Power Control 8291 © 2020 GUDE Systems GmbH
Configuration
Initialization status(coldstart): This is the port state (on, off, remember last state) the
port should be set when the device is turned on. The setting "remember last state" saves
the last manually set state of the power port in the EEPROM.
Initialization delay: Here can be configured how long the port should wait to switch to its
defined state after the device is turned on. The delay may last up to 8191 seconds. This
corresponds to a period of approx. two hours and 20 minutes. A value of zero means
that the initialization is off.
Repower delay: When this feature is enabled (value greater than 0), the power port will
switch itself on again a specified time after it has been disabled. Unlike the "
Reset " but-
ton this function applies to all switch actions, including SNMP, or an optional serial inter-
face.
Reset Duration: When the " Reset " button is triggered, the device turns the power port
off, waits for the time entered here (in seconds) and turns the power port on.
Configuration - Powerbanks
Powersource Bank X: With the banks B to D you can choose between 12V and 24V.
Bank A and Bank E have a fixed voltage.
3.1.1
Watchdog
The watchdog feature enables to monitor various remote devices. Therefore either ICMP
pings or TCP pings are sent to the device to be monitored. If these pings are not
answered within a certain time (both the time and the number of attempts can be set),
the port is reset. This allows e.g. to automatically restart not responding server or NAS
systems. The mode IP master-slave port allows you to switch a port depending on the
availability of a remote device.
When a watchdog is activated it presents various information in the Control Panel. The
information is color-coded.
· Green text: The watchdog is active and regularly receives ping replies.
· Orange text: The watchdog is currently enabled, and waits for the first Ping response.