GÜDE 95446, Translation Of The Original Instructions

Page: 41 / 112

37
Lift sensor
This sensor checks whether the wheels are in contact with the ground. If the robot lawnmower is lifted or if the
wheels run free, the robot switches off and must be restarted manually.
Tilt sensor
The robot lawnmower has an integrated 6-axis sensor that measures the tilt angle in all directions. If the tilt angle
exceeds 30°, the cutting motor stops immediately, but the mower continues to move. If the angle drops to less than
30° within 10 seconds, the cutting motor restarts automatically. However, if the angle does not decrease within 10
seconds, the mower will shut down and require a manual restart.
Error codes
Error codes: are shown on the LCD display
Caution: Manual restart - Place the unit within 1 metre of the boundary line, enter the correct PIN and press „Start“.
Error code Causes Removal
E1 Stop button has been activated. Restart the robot.
E2 Lift sensor has triggered. Has the robot been lifted? Wheels blocked?
If necessary, remove foreign objects and restart the
robot manually.
E3 Robot is outside the boundary lines. Position the robot within the boundary lines and
restart it manually.
E4 No boundary line signal. Check the status LED of the charging station. If the
LED flashes red, the boundary line is broken or the
boundary wire is not connected to the station.
Check connection
E5 A collision sensor was triggered. Remove all obstacles or reposition the robot and
restart it.
E6 Overload on the left drive motor. Grass is too high or dense? Wheels blocked?
If the grass is higher than 2.6 inches/ 6.6 cm, please
mow with traditional lawn mower. If the grass is
lower than 2.6 inches, please adjust the height on
the robot so that it works unhindered.
E7 Overload on the right drive motor. Grass is too high or dense? Wheels blocked?
If the grass is higher than 2.6 inches/ 6.6 cm, please
mow with traditional lawn mower. If the grass is
lower than 2.6 inches, please adjust the height on
the robot so that it works unhindered.
E8 Overload on the cutter motor. Grass is too high or dense? Wheels blocked?
If the grass is higher than 2.6 inches/ 6.6 cm, please
mow with traditional lawn mower. If the grass is
lower than 2.6 inches, please adjust the height on
the robot so that it works unhindered.
E9 Battery is defective Contact the service department.
E10 Undervoltage of the battery detected. Position the robot at the charging station and
restart it manually. If the problem persists, please
contact the service department.
E11 Tilt sensor triggered Incline angle greater than 30 degrees? Robot has
turned upside down?
Place the robot on a flat, level surface and restart it.
All wheels must touch the ground for this.
E12 Wheel turns without stop/grip.
Is the robot stuck in the sand or in a hole?
Check the lawn area. Place the robot on a flat, level
surface and restart it.
E13 Battery has overheated. Let it cool down, otherwise contact the service
department.
ENGLISH
EN