GÜDE 95446, Translation Of The Original Instructions

Page: 40 / 112

36
Common mistakes, causes and solutions
Checking the charging station
Problem Causes Removal
The robot lawnmower
does not leave the
station
Caution:
PIN forgotten?
Please contact the
Technical Service
PIN was entered incorrectly. Enter PIN again or use the factory setting
PIN (0000).
Battery is not charged. Charge the robot until all 4 charging bars of
the battery light up.
Charging station was not installed
correctly.
The arrow of the station should point to the
working area.
Perimeter wire not connected. / The
boundary wire has not been connec-
ted correctly.
The end of the cable should be connected to
the + pole under the station.
The initial route of the
robot is not correct.
Perimeter wire not connected. / The
boundary wire has not been connec-
ted correctly.
Adjust the boundary wire so that the robot
travels the desired path.
Disturbance caused by an under-
ground power source.
Lay the boundary wire around the source of
the obstacle again.
Robot does not auto-
matically connect to
the charging station.
The charging station is not straight or
level.
Place the station on an even surface / Place
the charging station on an even and level
surface.
Use of the robot lawnmower
Problem Causes
Removal
Loud noises and strong
vibration.
Cutting system is unbalanced. Blunt
blades
Switch off the appliance and replace all 3
blades.
Blade plate is damaged. Replace the blade plate.
Screws of the blade plate are loose. Carefully tighten the screws of the blade
plate.
Working time between
charging cycles de-
creases.
Charging contacts are dirty. Clean the charging contacts on the station
and on the robot. Clean easily with steel
wool.
Battery capacity reduced. Insert new battery
Robot does not leave
the station after the
rain sensor is activated
Rain sensor is active.
Dry and clean the metal contacts and restart
the robot.
Starting up the robot lawnmower
Problem
Causes Removal
Robot leaves the set
area or stops behind it.
Wheels are disabled/dirty. Clean the wheels or remove possible obstac-
les on the set surface.
Grass is too wet or a slope is too close
to the set limit.
Readjust the area to avoid the slope.
Do not use the appliance in rain or wet
conditions.
Sensors
Contact sensor
When the robot lawnmower encounters an obstacle, it turns around and takes a new path within 10 seconds. The
robot shuts down and requires a manual restart to continue operation.
Rain sensor
In heavy rain, the robot lawnmower automatically returns to the charging station. The following day, the mower
starts at the set start time.
ENGLISH
EN