GSI Group PNEG-1049, Assembly And Operation Manual

Page: 26 / 56

4. Assembly
26 PNEG-1049 10"-12" Commercial Bin Sweep Augers
29. Place the 1/4" square key on the keyway of the 3:1 aluminum enclosed drive input shaft. Place the
12" sheave onto the input shaft and key. The set screws of the sheave should be away from the
enclosed drive. Do NOT tighten the set screws. These will be adjusted after the motor and motor
sheave is in place.
(See Figure 4W.)
Figure 4W Sheave to Drive Assembly
30. Attach the motor (not supplied) to the top motor clips with the appropriate hardware (not supplied.)
31. Attach the motor sheave to the motor.
32. Adjust the position of the motor clips, motor sheave and the aluminum enclosed drive sheave to
achieve proper alignment. Tighten all set screws.
33. Place the two (2) belts over the sheaves. (See Figure 4X.)
Figure 4X Belts to Sheave