GSI Group PNEG-1049, Assembly And Operation Manual

Page: 16 / 56

4. Assembly
16 PNEG-1049 10"-12" Commercial Bin Sweep Augers
5. When installing the bin sweep in the bin, put two (2) 1" flat washers onto the post of the pivot yoke.
Place the drive assembly onto the center well pivot tube. (See Figure 4E.)
Figure 4E Drive Assembly to Center Pivot
6. Attach the discharge flight to the connecting shaft on the drive assembly using two (2) 1/2" x 3-1/2"
grade 8 hex bolts and stover nuts. The discharge flight is distinguished by the absence of flight ribbon
at one end. This end gets attached to the drive assembly.
(See Figure 4F.)
Figure 4F Discharge Flight to Drive