22
PNEG-1020 Bin Sweep Auger
10" Bin Sweep Assembly & Installation
5. Place the outer lock collar onto the
flighting shaft. This lock collar will be
located on the opposite side of the motor
mount assembly as the first one. Do not
tighten the collar.
Figure 5.1-E
5.2 Install the Pulley
1. Place the pulley onto the flighting shaft
making sure that the stub of the pulley is
facing inward toward the motor mount
assembly.
Figure 5.2-A
2. Turn the pulley wheel so that the roll pin
hole on the pulley shaft and the roll pin
hole on the tube align.
Figure 5.2-B
3. Insert a 5/16" x 2" roll pin into pin hole
located on the pulley stub. Drive the roll
pin, with a hammer and a punch, equally
through both sides of pulley.
Note: It may be necessary to pre-start the
roll pin. The pulley is separate from
the shaft as seen in
corner picture.
Figure 5.2-C
Collar
Pulley with stub
facing inward
Pin Hole
5/16" x 2"
Roll Pin
