18
PNEG-1020 Bin Sweep Auger
6" and 8" Bin Sweep Assembly & Installation
2. Place the bearing clamps together over
both bronze bushings using one (1) 5/16"
bolt, lock washer and nut for each bearing
clamp. Tighten the bolts.
Figure 4.7-B
4.8 Attach the Flighting to the
Shield
1. Connect the shield support bracket and
the torque clamp to the shield using two
(2) 5/16" x 1" bolts, lock washers and nuts
as shown in
Figure 4.8-A
2. Connect the bearing brackets and the
torque tube clamps to the shield using
four (4) 5/16" x 1" bolts, washers and nuts
for each area as shown in
.
Figure 4.8-B
Note: Make sure to place the head of the
bolts on the inside of the shield with
the threaded end protruding to the
outside.
4.9 Wheel
Assembly
1. Insert the sweep wheel shaft with non-
threaded end into the flighting tube
securing it with a 5/16" x 2" roll pin placed
in the hole located in the flighting tube.
Note: Make sure to place the 5/16" x 2" pin
in the inner positioned hole located
on the sweep wheel shaft leaving
one hole exposed.
Use a hammer and if needed a
punch to center the pin.
Figure 4.9-A
Bearing Clamps
Shield Support Bracket
Torque Tube Clamb
Sweep Wheel Shaft
