14
PNEG-1020 Bin Sweep Auger
6" and 8" Bin Sweep Assembly & Installation
4. 6" AND 8" BIN SWEEP ASSEMBLY & INSTALLATION
4.1 Install the Motor Mount on
the Flighting Drive End
1. Assemble the flange bearings on each
side of the motor mount assembly, using
5/16" x 3/4" carriage bolts with lock
washers and nuts.
Figure 4.1-A
Figure 4.1-B
2. Tighten the carriage bolts and nuts.
Figure 4.1-C
3. Place a lock collar onto the shaft. Do not
tighten.
4. Place the motor mount assembly onto the
shaft making sure that the hinge of the
motor mount assembly is facing outward.
Note: The bearing and motor mount
assembly is placed on the end of the
flighting shaft that is the longest
without flight.
Figure 4.1-D
Flange Bearing
Motor Mount
Assembly
Tighten Hardware
With Wrench
Lock Collar
Motor Mount
Assembly
