9
Mounting the unit
5 Mounting
Instruction book, IQAN- LC5-X05
5
Mounting
Mounting the unit
N
OTICE
The IQAN-LC5-X05 unit should be mounted according to the following instructions.
Mounting considerations
•
The control lever must be built in so that it is protected against direct pressurized
liquid spray (above flange) and excessive mechanical forces.
•
The machine manufacturer must consider the need of a protective catch, or similar,
to prevent unintentional working of the lever.
N
OTICE
Take careful consideration when positioning the unit.
•
Mount the unit so that it is not exposed to external heat, e.g. from the engine or
heater.
•
Mount the unit so there is no risk that the harness can be folded, crushed, worn or
damaged in any way.
•
Locate the harness so there is no pressure on the connector.
•
Use ergonomics. The control lever should be mounted at a height so that there is no
pressure on the driver's arm and shoulders. The IQAN-LC5-X05 and a well
designed handle, such as the MP, combined with moveable arm rests, can provide
good ergonomics.
N
OTICE
Do not exceed power supply limits for the joystick base and thumbwheel.
Reversed polarity, or supply voltage different from recommended operating conditions,
see Appendix A, on page 21, will seriously damage the unit.
Mounting methods
•
Control lever IQAN-LC5-X05 must only be mounted using screws through the
flange.
Mounting the IQAN-LC5-X05 with screws.
4x
