Exploded V i e w w i t h Key Numbers
Steering Knuckles: Slide the 14mm pivot balls into the knuckles, and pull them through until
they are properly seated. Place the 14mm pivot ball cups, cup side first, over the pivot balls. Place
the pivot ball nuts into the knuckles and carefully tighten. As you tighten the nuts, check to make
sure the pivot ball cups do not slide out of place. Continue to tighten until snug. Check the play of
the pivot ball against the pivot ball cup and nut. If the pivot balls have too much play/slop, continue
to tighten the pivot ball nut. Repeat this until the pivot balls bind slightly then back off the nut about
1/8 turn. Slide the small and large bearings into the knuckles. Slide the front universal drive shafts
through the bearings and attach wheel hubs with pin and set screw. If the drive shaft has too an
excessive amount of slop, disassemble and install an 8x16x0.5mm washer between the bearing
and the wheel hub. Install 6.8mm ball studs in hole.
