Grundig GCI-K2795P, Owner'S Manual

Page: 50 / 98

Select <Upload for __ sec> to set the recording duration after the alarm is triggered. The setting range is from 1
to 99999 seconds.
Select <Upload while trigger is active> to record the triggered video until the trigger is turned off.
NOTE: Please make sure the local recording (with Micro SD/ SDHC card) is activated so that this function can be
implemented. See section 9.1
4
. 'Recording (on Camera)' for further details.
- Send Message by FTP:
The Administrator can select whether to send an alarm message by FTP when Network Failure is detected.
- Send Message by E-Mail:
The Administrator can choose to send an alarm message by E-Mail when Network Failure is detected.
Save :
After completing all the settings mentioned above, please click on the Save button to save all the settings in this
page.
9.11. Periodical Event
The device will send the designated frame numbers to the SD card in a specified time frame/duration.
Enable this function by setting this mode to
<O
n
>
.
Set the Time Interval by choosing from 60s to 3600s.
Triggered Action:
- Enable the SD card recording by ticking the box next to “Upload image to sd card”.
- Pre-trigger buffer: The device will send designated frame numbers before the event (1~20 frames).
- Post-trigger buffer: The device will send designated frame numbers after the event (1~20 frames).
48 English