Gruetzner LUBRICUS LUB-V, User Manual

Page: 34 / 86

32
6.3.3 Perform a Quick-Check
The Quick-Check is used to activate the LUB-V by hand. In this way, a pump cycle PZ can be
triggered directly at the LUB-V. This function can be used, for example, to manually check the
condition of the lubrication point.
After the Quick-Check has been triggered, the LUB-V carries out a pump cycle PZ; the number of
lubrication strokes carried out per outlet is exactly as set in the variable Number of lubrication
strokes per lubrication cycle C in the Settings menu. During the lubrication strokes C, the coun-
terpressure per outlet measured by the integrated microelectronics is shown in the display as an
approximate value in the unit bar. After a completed lubrication stroke, the approximate maximum
counterpressure reached during the lubrication stroke is shown in bar on the display per outlet.
Procedure:

The LUB-V is switched on and there is no fault or error.

Remove the activation and programming key from the upper housing of the LUB-V and place it
on the action area.

Hold the activation and programming key on the action area. The double circle appears in the
bottom right corner. Leave the activation and programming key on the action area until Quick-
Check appears in the display. Remove the activation and programming key from the action area
until Quick-Check appears in the display. The double circle disappears.

The confirmation hook appears; the display and the hook flash twice for visual confirmation.
The LUB-V starts the pump cycle PZ.

Reattach the activation and programming key in the opening provided on the upper housing of
the LUB-V.

Observe the back pressure values displayed on the display if they are of interest to you.

During the pump cycle, the display shows the back pressure of the current lubrication stroke
depending on the outlet.
Outlet 1.1 Outlet 1.2