20
6.2
Factory settings
LUB-V is always delivered with the following factory settings:
operating mode:
hour mode -h-
mode:
OFF
LUB-V is switched off
The factory settings provide the use of LUB-V in hour mode -h-. If you would like to
operate LUB-V in impulse mode PUL you have to make changes in the SET menu of
LUB-V (chaper 6.3.8).
6.2.1 Default settings, operating mode: hour mode -h-
Pause time
h = 3
The pause time is 3 hours.
Number of cycles
c = 1
The number of cycles is one (1) stroke
per
outlet.
The default settings in hour mode when using a LUB-V with one (1) lubricant outlet
result in an emptying time (service life) of 338 days (= 11 months) for a full 400 ml
lubricant cartridge, provided that LUB-V is permanently switched on and no special
dispenses have been made. Within approx. 3 hours, LUB-V will deliver one dispense per
stroke (0.16 cm³).
If you are using LUB-V with one (1) lubricant outlet, one dispensing stroke will be
delivered from one outlet at the end of the pause time. If you are using LUB-V with two
(2) lubricant outlets, one stroke per outlet will be delivered at the end of the pause time.
The emptying time of the cartridge is halved.
l
Verify that the default settings are appropriate for your application and that
the lubrication point is supplied with the correct amount of lubricant per time unit.
If this is the case, you can operate LUB-V with the default settings in hour mode -h-.
If this is
not
the case change the values for the pause time h and number of cycles c
accordingly; see chapter 6.3.7 for an explanation of how to make these changes.
To use LUB-V it must be properly mounted and installed first and then switched on.
The installation is very simple and is described in detail in chapter 5.2; switching on is
described in chapter 6.3.3.
If you order a factory-provided special version of LUB-V, the information contained in
the supplement is authoritative.
